Character Brand New

DetonationEMS Pre-Ignition X4 Speeduino Standalone ECU KIT Case, Bluetooth

DetonationEMS Pre-Ignition X4 Speeduino Standalone ECU KIT Case, Bluetooth
DetonationEMS Pre-Ignition X4 Speeduino Standalone ECU KIT Case, Bluetooth
DetonationEMS Pre-Ignition X4 Speeduino Standalone ECU KIT Case, Bluetooth
DetonationEMS Pre-Ignition X4 Speeduino Standalone ECU KIT Case, Bluetooth
DetonationEMS Pre-Ignition X4 Speeduino Standalone ECU KIT Case, Bluetooth
DetonationEMS Pre-Ignition X4 Speeduino Standalone ECU KIT Case, Bluetooth
DetonationEMS Pre-Ignition X4 Speeduino Standalone ECU KIT Case, Bluetooth
DetonationEMS Pre-Ignition X4 Speeduino Standalone ECU KIT Case, Bluetooth
DetonationEMS Pre-Ignition X4 Speeduino Standalone ECU KIT Case, Bluetooth

DetonationEMS Pre-Ignition X4 Speeduino Standalone ECU KIT Case, Bluetooth
Budget Minded Engine Management without Compromise! This ECU is a universal standalone engine management system. As with all universal Standalone ECU's they are not "Plug and Play" and. We do not offer any vehicle specific installation instructions. This ECU is a Speeduino Compatible device and uses official Speeduino firmware. All Software, Firmware, Base-maps, Manuals, schematics and additional information links can be found on the DetonationEMS website. And Official Speeduino Wiki page. The Speeduino Project is an engine management project aims to create a flexible, fully featured Engine Management Systems based on the low cost micro-controller platforms such as Arduino and STM32.

Pre-Ignition x4 a flying lead ECU Fully Compatible with the the official Speeduino Firmware! Compatible with Board Selection "Speeduino v0.4". All hardware and firmware for Speeduino and DetonationEMS are open source! Hammond Extruded Aluminum Case with Custom 3d Printed End Caps.

2x12 and 2x10 Lead Connectors. (Enough Female Pins to make a few mistakes while crimping).

2x12 and 2x10 PCB Connectors. Arduino 2560 with latest Stable Official Speeduino firmware installed. Bluetooth Module for wireless tuning. Supports up to 8 cylinders fuel and ignition using 4 channels of fuel and 4 channels of ignition outputs, 2 (Even fire only), 3 and 4 cylinder engines with full sequential fuel and ignition. 6 (even fire only) and 8 cylinder engines are supported with wasted spark and 2 squirts per cycle.

4 - Injector channels (Ground Switching). 4 - Ignition outputs (12v/5v Selectable Logic Low-Current).

4 - Fully protected input channels for CLT, IAT, TPS and O2. 2 - Trigger Inputs (Crank, Cam Sensor). 1 - Optional Duel VR conditioner mount. 1 - 2.5-bar Map Sensor. 1 - External Map Sensor Input (New Jumper lets you select on board map usage for Engine OR Real time barometric pressure reading).

1 - DRV8825 stepper module mount location for Stepper Idle Control Valves. 4 - Customizable High-Current (1A max Ground Switching) Spare Outputs Idle Valve, Boost Control, VVT, etc.. 3 - Low-Current Pre-Configured Outputs (Tachometer, Relay Control for Fan & Fuel Pump). 3 - Customizable Low-Current (400ma max Ground Switching) Spare Outputs. 2 - Customizable Spare Analog Inputs Oil, fuel pressure etc.. 1 - Flex Fuel Sensor Input. 1 - Clutch Switch input (Ground Switching Only). 1 - Bluetooth Header for HC-05/HC-06 Bluetooth Module (See Speeduino Wiki for setup instructions). 16x16 3D fuel and ignition maps, with base of either TPS (Alpha-N) or MAP (Speed Density). 6x6 3D individual cylinder trim on engines up to 4 cylinders. Rev limiting (Spark based, hard and soft). Cranking specific enrichment, dwell timing and advance. General logging through Tuner Studio. TPS calibration through Tuner Studio. Sensor calibration through Tuner Studio (Coolant, IAT and O2).

Fuel pump activation/deactivation (With priming). Over dwell and over duty protection.

Battery voltage compensation for dwell and injectors. O2 based Autotune (Registered version of Tuner Studio required). Open and closed loop idle control (PWM and Stepper). Deceleration fuel cut off (DFCO). Fuel and oil pressure Using Auxiliary Analog input 5v Sensors only.

Generic programmable outputs (See wiki). Water and methanol injection (requires the use of additional inputs, see wiki). Vehicle Speed in MPH & KPH Logging and Display. All Software, Firmware, Base-maps, Manuals and additional information links can be found on the Speeduino Wiki page. Federal Regulations, California (CARB), other states and governing authorities prohibit sale or use of some aftermarket parts, including those that tamper with, modify or defeat emission systems in any vehicle 1966 and newer. DetonationEMS prohibits the use of it's products on emission controlled vehicles.

The item "DetonationEMS Pre-Ignition X4 Speeduino Standalone ECU KIT Case, Bluetooth" is in sale since Monday, September 28, 2020. This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts & Accessories\Starters, Alternators, ECUs & Wiring\ECUs & Computer Modules". The seller is "detonationems" and is located in Albany, New York. This item can be shipped to United States, Canada, United Kingdom, Australia, Mexico, Germany, Japan, Denmark, Romania, Slovakia, Bulgaria, Czech republic, Finland, Hungary, Latvia, Lithuania, Malta, Estonia, Greece, Portugal, Cyprus, Slovenia, China, Sweden, South Korea, Indonesia, Taiwan, South africa, Thailand, Belgium, France, Hong Kong, Ireland, Netherlands, Poland, Spain, Italy, Austria, Bahamas, New Zealand, Philippines, Singapore, Switzerland, Norway, Saudi arabia, Ukraine, United arab emirates, Qatar, Kuwait, Bahrain, Croatia, Malaysia, Brazil, Chile, Colombia, Costa rica, Panama, Trinidad and tobago, Guatemala, Honduras, Jamaica, Antigua and barbuda, Aruba, Belize, Dominica, Grenada, Saint kitts and nevis, Saint lucia, Montserrat, Turks and caicos islands, Barbados, Bangladesh, Bermuda, Brunei darussalam, Bolivia, Ecuador, Egypt, French guiana, Guernsey, Gibraltar, Guadeloupe, Iceland, Jersey, Jordan, Cambodia, Cayman islands, Liechtenstein, Sri lanka, Luxembourg, Monaco, Macao, Martinique, Maldives, Nicaragua, Oman, Peru, Pakistan, Paraguay, Reunion, Viet nam, Uruguay, Russian federation.

  • Manufacturer Part Number: Pre-Ignition x4
  • Brand: DetonationEMS
  • Manufacturer Warranty: 90 Day
  • Modified Item: No
  • MPN: x4
  • Fitment Type: Performance/Custom


DetonationEMS Pre-Ignition X4 Speeduino Standalone ECU KIT Case, Bluetooth